Need help?Do you have a question about the Kicker ZX350.2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Minimum Impedance Bridged | 4 Ohms |
| Minimum Impedance Unbridged | 2 Ohms |
| Frequency Response | 20Hz - 20kHz |
| Input Voltage | 14.4V |
| Fuse Rating | 30A |
| Crossover Frequency | 50Hz - 200Hz |
| Bass Boost | 0 - 18 dB |
| Input Sensitivity | 200mV - 4V |
| RMS Power at 2 Ohms | 100 Watts x 2 |
| Bridged RMS Power | 200 Watts x 1 |
| Signal to Noise Ratio | 95 dB |
| Crossover | Low-Pass/High-Pass |
Choose a structurally sound location to mount your Kicker amplifier, ensuring adequate ventilation.
Connect battery, ground, and power cables, ensuring correct gauge and fuse placement.
Diagrams showing common configurations for stereo and bridged operation.
Choose between +12V, DC Offset, or Audio for amplifier turn-on.
Set input level switch for Hi or Low-level signals from the source unit.
Set the internal crossover to OFF, HI (high-pass), or LO (low-pass).
Matches source unit output to amplifier input level, not a volume control.
Variable control for increased output 0-18dB at 40 Hz.
Adjusts the internal crossover frequency from 50-200Hz.
Remotely controls amplifier output level when set to LO pass.
Check power, remote turn-on, wiring, and fuses.
Check RCA connections, speaker outputs, and source unit.
Yellow LED indicates low battery voltage; check charging system.
Check thermal protection, impedance, and airflow; or voltage protection.
Check balance, RCA, and speaker connections; swap cables to diagnose.
Check RCA routing, source unit ground, and gain settings.
Check speaker phasing and wiring polarity.
May require additional grounding for head unit RCA outputs.
Details warranty periods, what's covered, and how to obtain service.
Steps for returning defective merchandise to Kicker or authorized dealers.
Lists conditions not covered by the warranty, like improper installation.
Advice to contact international dealers for country-specific warranty policies.
To Next Page
