Need help?Do you have a question about the Kicker ZX650.4 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Minimum Impedance Bridged | 4 Ohms |
| Minimum Impedance Unbridged | 2 Ohms |
| Frequency Response | 20Hz - 20kHz |
| Signal to Noise Ratio | >95 dB |
| Input Voltage | 14.4V |
| Fuse Rating | 30A |
| Speaker Level Inputs | Yes |
| Input Sensitivity | 200mV - 4V |
| RMS Power at 4 Ohms | 65W x 4 |
| RMS Power at 2 Ohms | 100 Watts x 4 |
| Bridged RMS Power | 200 Watts x 2 |
Instructions for securely attaching the amplifier to a solid surface, ensuring proper ventilation.
Guidance on connecting power, ground, and signal wires to the amplifier for safe operation.
Details for operating the amplifier in a four-channel configuration with minimum impedance.
Instructions for connecting speakers in a bridged (mono) configuration for higher power output.
Guide for simultaneous stereo and mono operation modes, specifying minimum impedances.
Steps to install the optional remote bass control unit for adjusting bass levels remotely.
Options for automatically turning the amplifier on via +12V, DC Offset, or Audio signal.
Selecting input signal type (Hi/Lo) and using the fader switch for dual input sets.
Adjusting crossover settings, input gain, and bass boost for optimal sound.
Diagnosing issues when the amplifier has no output, or the protection LED is active.
Addressing issues like channel dropouts, alternator whine, poor stereo image, and noise.
Guidance on speaker impedance compatibility and resolving ground noise issues.
Explains the warranty period, coverage, and what is not included.
Steps to follow for warranty service, including obtaining an RMA number.
To Next Page
