Need help?Do you have a question about the Kicker ZX200.4 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Minimum Impedance Bridged | 4 Ohms |
| Minimum Impedance Unbridged | 2 Ohms |
| Frequency Response | 20Hz - 20kHz |
| Signal to Noise Ratio | > 95 dB |
| Input Voltage | 14.4V |
| Crossover Frequency | 50Hz - 200Hz |
| Bass Boost | 0 - 18dB |
| Input Sensitivity | 200mV - 4V |
| Dimensions | 9.5" x 10.5" x 2.25" |
| RMS Power at 4 Ohms | 50W x 4 |
| RMS Power at 2 Ohms | 100W x 4 |
| Bridged RMS Power | 200 Watts x 2 |
| Crossover | Low Pass/High Pass |
Instructions for securely mounting the Kicker amplifier in a vehicle.
Detailed steps for connecting power, ground, and signal wires to the amplifier.
Diagrams and explanations for common amplifier setup configurations.
How to set the amplifier's automatic turn-on modes.
Explanation of setting input sensitivity for Hi or Low-level signals.
How to use the crossover switch for high-pass or low-pass filtering.
Guide to matching source unit output to amplifier input level.
Details on adjusting the variable bass boost feature.
Steps to diagnose when the power indicator is off and no sound.
Steps to diagnose when the power indicator is on but no sound.
Diagnosing issues based on LED status and lack of sound.
Troubleshooting one channel not working and audio noise problems.
Details on the warranty period and terms for Kicker products.
Steps to follow for returning defective merchandise for service.
List of conditions and damages not covered by the warranty.
Expected turnaround time for electronic component service.
Information for contacting international dealers regarding warranty.
Technical specifications for the Kicker ZX200.4 amplifier.
To Next Page
