Need help?Do you have a question about the Kicker ZX1500.1 and is the answer not in the manual?
General| Amplifier Class | D |
|---|---|
| Number of Channels | 1 |
| Peak Power | 3000W |
| Frequency Response | 20 Hz - 200 Hz |
| Signal to Noise Ratio | > 95 dB |
| Bass Boost | 0 - 18 dB |
| Fuse Rating | 120A |
| Impedance | 2-4 Ohms |
| RMS Power at 4 Ohms | 750W |
| RMS Power at 2 Ohms | 1500W |
| Low Pass Crossover | 24dB/octave |
Lists RMS power, length, and common dimensions for specific ZX models.
Explains adjustable crossover frequencies and bass boost levels.
Covers choosing a location and basic wiring connections for amplifier setup.
Details proper connection of power, ground, and fuses with wire gauge specs.
Explains connecting signal sources and remote turn-on leads.
Explains mono setup requirements and minimum impedance.
Details +12V, DC Offset, and Audio signal sensing for amp activation.
Explains signal input options and adjustable crossover settings.
Covers gain control, variable bass boost, and remote bass installation.
Addresses problems like no output, red badge light status, and protection LED.
Covers alternator noise, reduced bass response, and ground noise.
Outlines steps for obtaining warranty repair or replacement.
Lists conditions and damages not covered by the KICKER warranty.
Shows tested power output and test status for each ZX amplifier model.
To Next Page
