To Next PageTo Next Page
Need help?Do you have a question about the Kicker ZX450.2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Minimum Impedance Bridged | 4 Ohms |
| Minimum Impedance Unbridged | 2 Ohms |
| Frequency Response | 20Hz - 20kHz |
| Signal to Noise Ratio | > 95 dB |
| Input Voltage | 14.4v |
| Fuse Rating | 30A |
| Crossover Frequency | 50Hz - 200Hz |
| Bass Boost | 0 - 18 dB |
| Input Sensitivity | 200 mV - 4V |
| RMS Power at 4 Ohms | 75W x 2 |
Details power output for ZX200.2 and ZX450.2 models under specific conditions.
Lists common technical details like frequency response, impedance, and sensitivity for all models.
Guidance on securely mounting the amplifier and initial wiring connections.
Explains connecting RCA or speaker-level inputs from the source unit to the amplifier.
Specifies fuse size, power/ground wire gauge, and connection points.
Explains stereo, bridged (mono), and SAMS speaker configurations.
Instructions for installing the optional ZXRC remote bass control unit.
Details automatic turn-on options and input level selection.
Explains adjustment of crossover, input gain, and bass boost controls.
How to connect and use the ZXRC for remote bass level adjustment.
Diagnoses problems related to power, protection LEDs, and lack of audio output.
Addresses channel output, noise, grounding, and stereo image problems.
Information on the 3-year extended warranty with a qualifying KICKER Installation Kit.
Presents power output and signal-to-noise ratio ratings conforming to CEA-2006 standards.
Outlines limited warranty terms, coverage, exclusions, and service procedures.
Explains the process for obtaining an RMA number and returning defective merchandise.
