Need help?Do you have a question about the Kicker DX300.2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Rated Power (2 Ohms) | 150W x 2 |
| Bridged Power (4 Ohms) | 300W x 1 |
| Frequency Response | 20 Hz - 20 kHz |
| Signal-to-Noise Ratio | >95dB |
| Input Sensitivity | 200 mV - 4 V |
| Power Output (RMS) | 300W |
| Crossover | 12dB/Octave |
Covers physical mounting and electrical wiring procedures for the amplifier.
Explains the three automatic turn-on modes: +12V, DC Offset, and Signal Sense.
Describes how to select the input signal level (High or Low) for the amplifier.
Explains the function of the crossover switch (OFF, HI, LO) on the amplifier.
Details the variable crossover frequency adjustment for the amplifier.
Guides on setting the input gain to match the source unit output.
Explains the bass boost feature and its adjustment on the amplifier.
Troubleshoots issues when the power LED is off and there is no sound.
Troubleshoots issues when the power LED is on but there is no sound output.
Explains protection LED flashing due to low battery voltage.
Addresses protection LED issues related to thermal or voltage protection.
Covers troubleshooting for missing or low audio output from the amplifier.
Explains how to resolve engine noise interference.
Offers a solution for poor bass response due to speaker phasing.
Provides steps to eliminate ground loop noise in the audio system.
Outlines the procedure for obtaining warranty service for the amplifier.
Lists exclusions from the product warranty coverage.
Informs about the expected turnaround time for warranty service.
To Next Page
