Need help?Do you have a question about the Kicker DX1000.1 and is the answer not in the manual?
General| Amplifier Class | D |
|---|---|
| Number of Channels | 1 |
| THD at Rated Power | <1% |
| Signal to Noise Ratio | 95dB |
| Low Pass Filter | 50Hz - 200Hz, 24dB/octave |
| Impedance | 2 or 4 Ohms |
| Input Voltage | 14.4V |
RMS Power and common specifications for DX500.1 and DX1000.1 models.
Instructions for physically mounting the amplifier and connecting the wiring.
Details on external fuses, power/ground wire gauge, and KICKER wiring kits.
Diagrams for wiring single 2-ohm or two 4-ohm speakers for 1 ohm operation.
Explanation of turn-on modes (+12V, DC Offset, Audio) and input signal selection.
Guide to adjusting crossover frequency, input gain, and bass boost levels.
Instructions for installing and connecting the ZXRC remote bass control.
Diagnosing problems using LED indicators and basic checks.
Addressing alternator noise, reduced bass response, and ground noise.
Details on the three-year warranty extension with a qualifying KICKER Installation Kit.
Coverage, duration, exclusions, and procedures for warranty service.
To Next Page
