Need help?Do you have a question about the Kicker DX125.2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Minimum Impedance Bridged | 4 Ohms |
| Minimum Impedance Unbridged | 2 Ohms |
| Frequency Response | 20Hz - 20kHz |
| Input Voltage | 14.4V |
| Bass Boost | 0 - 12 dB |
| Crossover Frequency | 50Hz - 200Hz |
| Input Sensitivity | 200mV - 4V |
Introduces the DX125.2 and DX300.2 amplifier models covered in the manual.
Lists detailed technical specifications for the DX125.2 and DX300.2 amplifiers.
Offers advice for optimal performance and warranty extension.
Guides on choosing a secure and ventilated location for amplifier mounting.
Provides initial instructions for connecting power, ground, and remote turn-on wires.
Illustrates different speaker wiring setups for stereo, mono, and SAMS modes.
Explains automatic turn-on methods: +12V, DC Offset, and Audio.
Covers input level, crossover settings, and frequency adjustments.
Guides on setting input gain and adjusting bass boost for sound tuning.
Addresses scenarios with green LED off or on, and no audio output.
Covers protection LED behavior and common noise problems like alternator whine.
Addresses issues like low output, reduced bass response, and ground noise.
Details a three-year warranty extension with qualifying installation kits.
Lists CEA-2006 compliant specifications for models DX125.2 and DX300.2.
Outlines procedures for obtaining warranty service and returning defective merchandise.
Lists conditions and damages not covered by the limited warranty.
Provides information on expected service turnaround and contact details.
Advises contacting international dealers for country-specific warranty procedures.
Warns about potential hearing damage from high sound levels and distortion.
To Next Page
