Need help?Do you have a question about the Kicker DX400.4 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| RMS Power @ 4 Ohms | 50W x 4 |
| Frequency Response | 20 Hz - 20 kHz |
| Signal to Noise Ratio | > 95 dB |
| Input Sensitivity | 200 mV - 4 V |
| Fuse Rating | 25A |
| RMS Power @ 2 Ohms | 100 Watts x 4 |
| Bridged RMS Power @ 4 Ohms | 200W x 2 |
| Bass Boost | 0 - 12 dB |
Details RMS power output and other performance metrics for DX200.4 and DX400.4 models.
Lists physical dimensions, frequency response, signal-to-noise ratio, and input sensitivity for all models.
Guidance on selecting a secure location and properly mounting the amplifier.
Steps for safely connecting the amplifier, including battery, ground, and remote turn-on.
Diagram illustrating speaker connections for four-channel output mode with minimum impedance.
Diagram showing speaker connections for mono bridged output mode with minimum impedance.
Diagram for connecting speakers in both stereo and mono bridged modes.
Explains how to select the amplifier's turn-on mode: +12V, DC Offset, or Audio.
Details on setting input sensitivity and using the crossover switch and control.
Instructions for adjusting input gain, fader, and bass boost controls for optimal sound.
Steps to resolve issues when the amplifier has no audio output, checking LED status.
Troubleshooting thermal, voltage, or short circuit protection modes.
Diagnosing and fixing alternator noise, ground noise, or reduced bass response.
Instructions on how to obtain warranty service and return defective merchandise.
Details on conditions and damages not covered by the KICKER warranty policy.
To Next Page
