Kicker IX1000.1 User Manual

2
IX AMPLIFIERS
IX.1-SERIES AMPLIFIERS Owner’s Manual
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4” (10cm) of open
ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled passenger compartment.
Drill four holes using a 7/64” (3mm) bit and use the supplied #8 screws to mount the amplifi er. Use the IXSM
mounting bracket (sold separately) to stack IX amplifi ers of different sizes.
PERFORMANCE
Authorized KICKER Dealer:
Purchase Date:
Model Number:
Serial Number:
Model: IX500.1 IX1000.1
RMS Power
@ 14.4V, 4 mono, d 1% THD+N
@ 14.4V, 2 mono, d 1% THD+N
275W x 1
500W x 1
550W x 1
1000W x 1
Length 9-3/8” (238mm)
Height 2-3/16” (55mm)
Width 7-7/8” (200mm)
Frequency Response ± 1dB 25Hz–200Hz
Signal-to-noise Ratio 95dB, A-weighted, re: rated power
Input Sensitivity Low Level: 125mV–5V
High Level: 250mV–10V
Selectable Electronic Crossover Variable lo-pass 50–200Hz, 24dB/octave
Bass Boost Variable 0–18dB @ 40Hz
Subsonic Filter 24dB/octave, fi xed @ 25Hz
Maximum Effi ciency (2) >80%
Pro Tip: To get the best performance from your new KICKER Amplifi er and extend the warranty by 1 year, use
genuine KICKER accessories and wiring.
IX500.1 / IX1000.1

Kicker IX1000.1 Specifications

General

Brand	Kicker
Model	IX1000.1
Category	Amplifier
Language	English