Kicker KX1200.1 - Specifications Common to All Models

10
KX Amplifiers
Specifications
Performance
MODEL KX400.1 KX600.1 KX1200.1
RMS POWER in Watts, All Channels Driven
@ 14.4Vdc, 4Ω Mono, 1.5% THD+N 1 x 200 1 x 300 1 x 300
@ 2Ω Mono, 1.5% THD+N 1 x 400 1 x 600 1 x 600
@ 1Ω Mono, 1.5% THD+N N/A N/A 1 x 1200
@ 12.5Vdc, 4Ω Mono, 1.5% THD+N 1 x 170 1 x 255 1 x 215
@ 2Ω Mono, 1.5% THD+N 1 x 340 1 x 510 1 x 525
@ 1Ω Mono, 1.5% THD+N N/A N/A 1 x 1050
Length with EndKaps: 12.75” 16” 22.5”
(32.38cm) (40.64cm) (57.15cm)
SPECIFICATIONS COMMON TO ALL MODELS
Height: 2.5 inches / 6.35 centimeters
Width: 10.125 inches / 25.7 centimeters
Length Without EndKaps: Subtract 5” (12.7 cm) from chart above
Frequency Response: 20Hz - 200Hz, + 0/- 1dB
Input Sensitivity: 170mV - 5V low level, 340mV - 10V high level
Signal-to-Noise Ratio: >95dB, a-weighted, re: rated power
Electronic Crossover: Variable high or low pass, 50 - 200Hz,
12dB/octave
KickBass Boost: Variable 0 to +18dB boost @ 40Hz
Model KX400.1
200 x 1 @ 4 ohms, 14.4Vdc, 1% THD,
CEA-2006 (Watts)
Signal to Noise Ratio -55
CEA-2006 (ref: 1W, A-weighted)
Model KX600.1
300 x 1 @ 4 ohms, 14.4Vdc, 1% THD,
CEA-2006 (Watts)
Signal to Noise Ratio -65
CEA-2006 (ref: 1W, A-weighted)
Model KX1200.1
300 x 1 @ 4 ohms, 14.4Vdc, 1% THD,
CEA-2006 (Watts)
Signal to Noise Ratio -65
CEA-2006 (ref: 1W, A-weighted)