Kicker XS100 - System Diagrams; Two Channel Operation; Bridged Operation

6
SYSTEM DIAGRAMS
These diagrams show minimum operating impedances for each system configuration
The XS-Series KICKER amplifiers need low impedances to make full power. In stereo mode
the amplifier will make all available power at 1/2 Ohm per channel. Likewise, 1 Ohm mono
is the impedance necessary to get full power out of the amp.
TWO CHANNEL OPERATION
In conventional stereo or two channel operation, a signal is required for each
channel and a speaker load of no less than 1/2 Ohm is connected to each of the right
and left outputs.
BRIDGED OPERATION
For bridged mono systems, an input is required to both input connectors and the speak-
er load of no less than 1 Ohms is connected to the left+ and right-.
REMOTE TURN-ON
RCA INPUT L
+
R
RCA OUTPUT L
+
R
GAIN
ZRX MODULE
LEFT
SPEAKER(S)
MINIMUM LOAD IMPEDANCE
1/2Ω EACH CHANNEL
RIGHT
SPEAKER(S)
GROUND
BATTERY
FUSE
+
+
–
+
–
–
+
–
+12V
America’s Music Machines
REMOTE TURN-ON
RCA INPUT L
+
R
RCA OUTPUT L
+
R
GAIN
ZRX MODULE
MONO
SPEAKER(S)
GROUND
BATTERY
FUSE
+
+
–
+
–
–
+12V
MINIMUM LOAD IMPEDANCE 1Ω
America’s Music Machines
ZRX BYPASS MODULE
ZRX LOWPASS MODULE