To Next PageTo Next Page
Need help?Do you have a question about the Kicker PXIBT100.2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Rated Power (Watts RMS) | 100 |
| Frequency Response | 20Hz-20kHz |
| Bluetooth | Yes |
| Rated Power at 2 Ohms | 100W x 2 |
| Signal-to-Noise Ratio | 90dB |
| Rated Power at 4 Ohms | 50 Watts x 2 |
| Crossover | 12dB/octave, selectable high-pass 60Hz, 80Hz, 120Hz, off |
To get the best performance from your KICKER Amplifier and extend the warranty by 1 year, use genuine KICKER accessories and wiring.
Choose a structurally sound location for mounting, ensuring adequate ventilation and avoiding obstructions behind screw points.
Connect the PXIBT harness to the amplifier, ensuring a good ground connection and installing a 15A fuse within 18" of the battery.
Set the internal crossover using HI-PASS switches to 60Hz, 80Hz, 120Hz, or OFF. Never change while the audio system is on.
Receive audio via Bluetooth, 3.5mm auxiliary, or USB. Enter Bluetooth pairing mode by holding PLAY-PAUSE.
Hold the Track button for 5 seconds to adjust LED brightness using volume buttons.
Diagnose problems like blue LED off or on with no output by checking power, remote turn-on, RCA connections, and speakers.
Address protection LED indications like flashing red (low battery) or solid on (thermal/voltage/short circuit protection).
Resolve issues like low output, alternator noise, or reduced bass response by checking connections, gain, and wiring.
Details on how to obtain warranty service, what is covered, and what is not covered by the KICKER warranty.
Information regarding FCC rules for digital devices, radio frequency energy, and RF exposure limits.
