Need help?Do you have a question about the Kicker PX100.2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Frequency Response | 20Hz - 20kHz |
| Signal-to-Noise Ratio | > 90dB |
| Input Sensitivity | 200mV - 4V |
| Bridged Power (RMS) | 200W |
| Crossover | High-pass/Low-pass |
| Power Output | 100W x 2 @ 4Ω |
Details amplifier power output at 2 and 4 Ohm stereo configurations.
Provides length, width, and height measurements of the amplifier.
Summarizes frequency response and signal-to-noise ratio.
Details input sensitivity ranges and selectable crossover frequencies.
Advice on optimizing performance and extending the product warranty.
Guidance on selecting a location and securely mounting the amplifier.
Steps for connecting power, ground, remote turn-on, and audio signals.
Explains selection of +12V or DC Offset for automatic amplifier turn-on.
How to set the input level switch for high or low-level signals.
Details on using the HI-PASS switch and selecting crossover points.
Procedure for matching source unit output to amplifier input gain.
Steps to diagnose issues when the amplifier has no sound.
Troubleshooting protection LED indicators for various faults.
Diagnosing low output, noise, and reduced bass response.
Instructions on how to obtain warranty service and necessary documentation.
Lists specific conditions and damages not covered by the warranty.
Information on the expected time for warranty repairs.
To Next Page
