6. Battery
NOTE: One Lithium battery, permanently sealed inside the
alarm, powers this unit; no battery installation or replace-
ment is necessary for the life of the alarm.
WARNING! DO NOT ATTEMPT TO OPEN THE ALARM FOR
ANY REASON!
To activate the alarm, attach the alarm to the mounting bracket by
rotating in the direction of the arrows on the cover, see
ACTIVATING ALARM in Section 3 (INSTALLATION INSTRUCTIONS).
Low battery: This alarm has a battery monitor circuit which will
cause the alarm to "chirp", (every 40 to 45 seconds), when the
battery is low. The alarm will "chirp" for a minimum of thirty (30)
days. REPLACE THE ALARM IMMEDIATELY.
THE UNIT MUST BE DISCHARGED (see “Permanently Disable
Alarm / Discharge Battery” section) when alarm is in “low
battery” condition.
To Next Page
Loading...
