8
5. Introduction, Product Features and Specifications
INTRODUCTION
This alarm detects products of combustion using photoelectric technology. Ten (10) years after the unit is
installed, this unit will automatically alert you that it is time to replace the unit. This is called “End of Unit Life”
mode. See Troubleshooting Guide. To help identify the date to replace the unit, a label has been affixed to the
side of the alarm. Write in the “Replace by” date (10 years from initial power up) in permanent marker on the
label prior to installing the unit.
NOTE: AC power must be connected to obtain the full 10 year battery and unit life.
PRODUCT FEATURES AND SPECIFICATIONS:
• Temperature: Operating Range: 4.4°C (40°F) to 37.8°C (100°F)
• Humidity: Operating range: up to 95% RH non-condensing
• Audible Alarm: 85+ dB at 10’ 3.0 to 3.5 KHz pulsing alarm, with voice message “Fire!”
•
NOTE: This is not a CO alarm, but it will receive and transmit a CO alarm signal (with voice message
“Warning! Carbon Monoxide”) from an interconnected CO or combination smoke/CO alarm.
• Smoke Sensor: Photoelectric
• Voice message system
• Smoke Alarm Hush® Control
• Ambient Light Sensing
• Powered by 120 V AC (60 Hz, 53 mA max) wire-in connector with sealed lithium battery backup.
• Hardwire and wireless interconnectable to other compatible alarms.
• One large, user- friendly button.
• LED safety light on model P4010LACS-WCA to help illuminate escape pathways.
To Next Page
Loading...
