EasyManuals Logo

Kidde P4010DCS-W User Manual

Kidde P4010DCS-W
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
18
9.3 Resetting a Devices Wireless Settings
If you encounter an issue at any point during the wireless network setup process, you may reset the device by following
the directions below.
A. BEGIN RESET
Press and hold the button on the device for 8-9 seconds until you hear 3
beeps. Release button. You will hear the words “Resetting wireless settings.”
B. CONCLUDE RESET
Light ring will flash green once and then it will pulse red. You will hear the
words, “Ready to connect, follow quick start instructions.”
Device has been reset.
See Section 9.1 to begin set-up of a new wireless alarm network,
or Section 9.2 for adding this device to an existing alarm network.
NOTE: If no further steps are taken within 15 minutes of resetting the unit’s wireless settings, a voice prompt “No
devices found, not connected” will be heard once, and the wireless function will turn off. The unit will then perform as
a stand alone alarm. See Section 9.2 for adding this device to an existing alarm network.
Figure 9.3-A
Hold for
8-9 seconds
“Resetting
wireless
settings.
Figure 9.3-B
“Ready to
connect, follow
Quick Start
instructions.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kidde P4010DCS-W and is the answer not in the manual?

Kidde P4010DCS-W Specifications

General IconGeneral
ModelP4010DCS-W
TypeSmoke Alarm
SensorPhotoelectric
Hush FeatureYes
Test ButtonYes
Voice AlarmYes
Tamper ResistantYes
Smart FeaturesNo
Alarm Sound85 dB at 10 feet
LED IndicatorYes
MountingCeiling or wall
Weight0.5 lbs
ComplianceUL 217
InterconnectivityYes
Battery Backup10-Year Sealed Battery
Dimensions5.59 x 5.59 x 1.91 inches

Related product manuals