12
Reset Button Access
To keep your RemoteLync Monitor in good working order, please
follow these simple steps:
• Verify the operation of the monitor’s voices and LED lights by
conducting a test once a week.
• Once a month, clean the monitor by using a soft brush
attachment, vacuum the front vents to remove dust and dirt.
After cleaning conduct a test to verify operation.
• Never use detergents or other solvents to clean the unit.
• Avoid spraying air fresheners, hair spray, or other aerosols
near the monitor.
Do not paint the monitor. Paint will seal the vents and interfere
with the sensor’s ability to detect alarm signals. Never attempt
to disassemble the unit or clean inside. This action will void
your warranty.
CAUTION: YOUR ACOUSTIC MONITOR IS SEALED AND THE
COVER IS NOT REMOVABLE!
Weekly testing is recommended. If at any time the monitor does not
perform as described, please verify that it is correctly inserted into the
wall outlet, and is connected to your home network. If the monitor
still does not appear to be operating properly, call Product Support as
shown at the end of the user guide.
Reset Function
The reset function can be used to return the monitor to its factory
settings and re-start the setup and enrollment processes. Using a small
pin or paper clip, press and hold the reset button on the side of the
monitor for 5 seconds while plugged in (until
LEDs start flashing). Then unplug and re-insert
the monitor into the power outlet to re-start the
setup process.
Maintenance Information
Operating Instructions
To Next Page
Loading...
General