4
1. Please read the operating manual thoroughly and comply with safety regulation to operate this Multi-Function
Controller.
2. Please grasp the plug of power cord while plugging in or out the plugs of connecting cord of Electric Screwdriver and
power cord.
3. Please fix the power controller to avoid any danger of pulling and dragging the power cord.
4. Do not near oil, chemical materials or heated objects, also please be alert not to scratch the power cord by sharp
object.
5. This type of Controller can only be applied to KILEWS Electric Screwdriver with Counter. Do not use Electric
Screwdriver Controller on other types of machinery.
6. In case of the Controller is overheated or overloaded with maximum current rating of fuse, the high-speed fuse will be
melt down and cut off the power. If the Controller continues to jump off or has an abnormal switching reaction, please
stop the operation immediately and send back the Controller for repair.
7. When Electric Screwdriver is running, if slides Forward/Reverse Switch instantly, device will generate the protection
program to force Electric Screwdriver stop.
8. Please do not disassemble Electric Screwdriver casually and try to repair it by self.
9. When Controller is not in use, please turn the main power switch OFF and unplug the power.
10. The electric frequency will be lower when the voltage is adjusted as Lo or below 32V, so the torque of the electric
screwdrivers can't be worked out except below scale of 4.
＊ Please arrange to use the whole set of Electric Screwdriver SKD-BN series except SKD-BN series with the
Multi-Function Controller.
＊ Please arrange to use together with KILEWS SKD-BN series Electric Screwdriver. If operator uses different brand of
Electric Screwdriver and repair tools with parts or accessories not from KILEWS manufacturer, it may cause the
Controller malfunction or poor quality. As a result, all of product guarantees will be void and no obligation to the
manufacturer.
＊ When Electric Screwdriver is running, if operator slide Forward/Reverse switch instantly, device will turn on the
protection program to force the Electric Screwdriver stop running.
＊ Don't swtich HI/LO changeover button when the screwdriver is running.
＊ To plug or unplug the DC connector must wait the LED OFF after power off.
To Next Page
Loading...
Need help?
General
