To Next PageTo Next Page
Need help?Do you have a question about the Kimberly-Clark PROFESSIONAL SCOTT PRO and is the answer not in the manual?
General| Brand | Kimberly-Clark PROFESSIONAL |
|---|---|
| Product Line | Scott Pro |
| Category | Dispenser |
| Material | Plastic |
| Color | Black |
| Compatible Products | Scott Pro Roll Towels |
| Mounting Type | Wall Mount |
| Mounting | Wall |
| Dispenser Type | Towel Dispenser |
Locate dispenser position using a stud finder and mark the rough wall opening.
Ensure adequate space for door swing (min. 8 inches) and note door reversal possibility.
Cut an investigation hole to check for obstructions and use tools for visual inspection.
Mark opening 12 inches from counter and 48 inches from floor for ADA compliance.
Mark the rough opening and begin the cut, respecting counter clearance.
Test the fit of the dispenser within the prepared wall opening.
Add or balance framing using 2x4s and 1x4s for 16-inch centers.
Measure the dispenser fit again and use shims if necessary for optimal alignment.
Install dispenser using 4 screws, ensuring the unit is level before fastening.
Align and gently push the module into the back housing until it clicks.
Apply the operating label inside the door and then install the door.
Install 'c' clips on hinges to keep the dispenser cover securely in place.
Close the dispenser door after all internal components are installed.
Affix the final use label onto the dispenser; it is now ready for operation.
