Kimberly-Clark Suretouch User Manual (English)

Need help?

Do you have a question about the Kimberly-Clark Suretouch and is the answer not in the manual?

Kimberly-Clark Suretouch Specifications

General

Prepare the countertop by drilling a 1" hole and mounting the support shaft securely.

Connect the soap discharge head to the support shaft and secure it with the set screw and caulk.

Connect the signal cable and motor module to the assembly, ensuring proper alignment and locking.

Install the battery compartment and connect the power cable to the motor module for operation.

Install the soap refill bottle, prime the pump, and prepare the dispenser for use.

Learn how to properly remove an empty soap refill bottle using the release tabs.

Instructions for temporarily deactivating the dispenser for cleaning purposes.

Explanation of the LED lights on the soap discharge head for status and troubleshooting.

Configure the sensor range for optimal soap dispensing based on environment.

Select between Standard Traffic, High Traffic, and Double Shot modes for soap delivery.

Set the motor module switch according to the soap refill size being used (800ML or 1500ML).

Solutions for common issues encountered during installation and operation of the soap system.

Information regarding ADA compliance and disclaimer of liability for installation.