Kimberly-Clark PROFESSIONAL 09508

To Next Page

For available spare parts contact your sales representative.

Enclosed Tools Required:

Product Codes

09508 White, 09507 Black

KIMBERLY-CLARK PROFESSIONAL™ JUMBO ROLL TOILET

PAPER DISPENSER

(x4) (x4) (x1)

DISTRIBUTRICE DE PAPIER HYGIÉNIQUE EN ROULEAU GÉANT KIMBERLY-CLARK

PROFESSIONAL™

Install Dispenser Bracket

Installation

IMPORTANT! For secure mounting, follow these

instructions thoroughly. Ensure that the proper

mounting hardware is used for the appropriate wall

type.

1. Assess wall surface material to determine if

screw anchors are required.

2. Mount the dispenser with the bottom edge

approximately 15-48” from the oor and

7-9” from the front edge of the toilet to the

centerline of the dispenser. In the presence

of a grab bar rail, mount dispenser so that

the outlet is no greater than 12” above the

bar, or so that the top of the dispenser is no

less than 1.5” below the bar.

3. Use 4 mounting screws as a minimum to

attach the dispenser to a wall.

Form 034162

Use correct

drill bit for

anchor size

*Check for ADA regional

& local installing/

mounting requirements.

7 - 9”

Need help?

Do you have a question about the Kimberly-Clark PROFESSIONAL 09508 and is the answer not in the manual?

Summary

Installation

Mounting Guidelines

Assess wall material, mount dispenser at specified heights and distances from toilet, check ADA.

Mounting Requirements

Evaluate wall material for anchors, mount dispenser at specified distances, consider grab bars.

Optional Push Button Lock Feature

Converting to Pushbutton Operation

Depress lock spring, remove plug, insert pushbutton from inside, re-engage lock spring.

Loading Instructions

Empty Dispenser Loading

Open dispenser, install new roll on left hub clockwise, allow 3 inches paper, close cover.

Partial Roll Loading (Left Hub)

Remove partial roll from left, flip for counterclockwise on right, rewind edge, install new roll on left.

Partial Roll Loading (Right Hub)

Rewind partial roll on right hub, remove empty core from left, install new roll on left.