NTang – MP100 – 120 - 12/08 B – We reserve the rigth to modify the characteristics of our products without notice.
Once returned to KIMO, required waste collection will be assured in the respect of the environment in accordance to 2002/96/CE guidelines relating to WEEE.
Functions available from main screen
How to change battery
1. Remove the front part at the back of the
instrument.
2. Remove old battery.
3. Insert the new battery in accordance with proper
polarity drew inside the housing.
4. Replace the front.
Velocity
activation
1x
Select air
velocity unit
Press to activate or deactivate Validate with
Press to scroll down units Validate with
Ambient
Temp.
6x
Enter value with Validate with
Atmospheric
Pressure
7x
Enter value with Validate with
Select
pressure unit
Press to scroll down units Validate with
Automatic
shut-off
Press to scroll down units Validate with
Beep
Press to activate or deactivate Validate with
2x
3x
4x
5x
Select pressure
units
Press to scroll down units Validate with
1x
Automatic
shut-off
Press to scroll down minutes Validate with
2x
Beep
Press to activate or deactivate Validate with
3x
Self-calibration
1x
Start of self-calibration countdown*
Functions available from main screen (only for MP120 instrument)
Self-calibration
1x
Start self-calibration countdown*
*self-calibration is performed by disconnecting the two pressure inlets of the sensor, then by pressing AutoZ key.
Using Pitot tube
1. Connect the Pitot tube to MP120 instrument.
2. The probe must be placed at the center of the duct and
parallel to the air flow.
3. Press then to activate velocity.
Dynamic pressure = PT - PS
+
-
(+) Static
Pressure PS
(-) Total
Pressure PT
To Previous Page
Loading...
Need help?
General
