Kimo MP Series - User Manual

PERFORM A MEASUREMENT
➢
Turn on the device by pressing on «On/Off/Esc».
The device displays its name «MP110», «MP111», «MP112» or «MP115», then performs an autozero.
➢
Connect the pressure tubes.
The device displays the pressure.
Manometer
MP 110 – MP111 – MP112 – MP 115
OK key
On/Off/Esc key
Hold/min/max keySelect key
Backlight key
PERFORM AN AUTOZERO
The device is on and displays the pressure measurements.
➢
Press on «OK».
«Autozero» displays on screen, the device performs an autozero then returns to the measurements display.
DESCRIPTION OF THE DEVICE
info@digiparts.chwww.digiparts.ch
DigiParts GmbH

Kimo MP Series Specifications

General

Warranty	2 years
Measured Parameters	Pressure, Temperature, Humidity, Air Velocity, Air Flow
Humidity Range	0 to 100 %RH (depending on model)
Air Flow Range	0 to 99999 m³/h (depending on model)
Pressure Units of Measurement	hPa, mmHg, psi
Resolution	0.1 °C (Temperature), 0.1% RH (Humidity), 0.01 m/s (Air Velocity)
Operating Temperature	0 to +50 °C
Operating Humidity	10 to 90 %RH non-condensing
Storage Humidity	10 to 90 %RH non-condensing
Functions	Max/Min values
Connectivity	USB (depending on model)
Temperature Range	-20 to 60 °C
Storage Temperature	-20 to 60 °C

Summary

Description of the Device

Perform a Measurement

Perform an Autozero

Freeze the Measurement

Display Maximum and Minimum

Adjust Device Settings

Device Drop-down Menu Navigation

Navigates through device settings via a menu system.

Select Pressure Measuring Unit

Configures the pressure unit display (e.g., daPa, mmH2O, kPa).

Adjust Auto Shut-off Timer

Control Key Beep Feedback

Activate Device Backlight

Change Device Batteries