Kimo MP Series - Freeze the Measurement; Display Maximum and Minimum; Adjust Device Settings; Device Drop-down Menu Navigation

DISPLAY THE MAXIMUM AND THE MINIMUM
Once the measurement are frozen:
➢
Press once on « Hold/min/max ».
The device display the maximum value of pressure measured since the last questioning at the top of the screen and the minimum value of
pressure measured since the last questioning at the bottom of the screen.
➢
Press on «On/Off/Esc» to return to the measurement display.
ADJUST THE DEVICE
Select the measuring unit in pressure:
The device is on and displays the measurement.
➢
Press on « Select».
«UNIT» blinks on screen.
➢
Press on « OK ».
The unit currently used blinks on screen.
➢
Press on «Select» until the required unit appears: daPa, mmh2O, kPa, inWg, mbar, mmHg...
➢
Press on « OK» to validate.
«UNIT» blinks on screen.
➢
Press on «On/Off/Esc» to return to the measurement display.
●
Device drop-down menu
Select1x
SEL.
UNIT
mmh
2
O
2x
Select Select
3x
SEL.
BEEP
OFF
SEL.
AUTO
OFF
OFF
OK
SEL.
UNIT
kPa
OK
SEL.
UNIT
mmh
2
O
UNIT
SEL.
mmh
2
O
UNIT
SEL.
mmh
2
O/kPa...
0, 108
kPa
1x
On/Off/
Esc
Select Select
FREEZE THE MEASUREMENT
During a measurement:
➢
Press on «Hold/min/max».
«Hold» appears on the screen and the measurements are frozen.
➢
Press on « On/Off/Esc» to exit the hold function.
The device returns to the measurement display.
info@digiparts.chwww.digiparts.ch
DigiParts GmbH