The exact position and fit of the log pieces may be finely adjusted to give the most
pleasing and random appearance. Re-fit the fascia and ashpan cover which are
held in place by magnets.
Warning : Use only the log pieces supplied with the fire. When
replacing the log pieces remove the old log pieces and discard them. Fit a
complete set of log pieces of the correct type. Do not fit additional log
pieces or any log pieces other than a genuine replacement set.
To ensure that the release of fibres from these R.C.F (Refractory Ceramic
Fibre) articles is kept to a minimum, during installation and servicing we
recommend that you use a HEPA filtered vacuum to remove any dust
accumulated in and around the appliance before and after working on the
appliance. When replacing these articles we recommend that the replaced
items are not broken up, but are sealed within heavy duty polythene bags,
clearly labelled as “RCF waste”. RCF waste is classed as a “stable”, non
reactive hazardous waste and may be disposed of at a landfill licensed to
accept such waste Protective clothing is not required when handling these
articles, but we recommend you follow the normal hygiene rules of not
smoking, eating or drinking in the work area, and always wash your hands
before eating or drinking.
22
IMPORTANT NOTE
BEFORE PROCEEDING TO LIGHT THE
APPLIANCE, ENSURE THAT THE PROTECTIVE
FILM COVERING THE INNER REAR PANEL HAS
BEEN REMOVED. FAILURE TO REMOVE THIS
PROTECTIVE FILM WILL
RESULT IN DAMAGE
TO THE REFLECTIVE INNER PANEL.
GUARANTEE CLAIMS WILL NOT BE ACCEPTED
FOR DAMAGE TO THE REFLECTIVE INNER
PANEL OF THE FIREBOX IF THE PROTECTIVE
FILM IS NOT REMOVED PRIOR TO INITIALLY
LIGHTING THE FIRE.
To Next Page
Loading...
