4.7.5 Loosen the pilot nut and remove the two screws retaining the pilot
assembly. Unscrew the thermocouple from the gas valve.
4.7.6 Re-assemble in reverse order and carry out a gas tightness test. Re-fit
the “Concept” fascia.
4.8 Replacing the Batteries (Within the Radio Frequency Receiver)
4.8.1 Prepare work area (lay down dust sheets etc.)
4.8.2 Remove the “Concept” fascia from the product and put it in a safe
location.
4.8.3 The RF receiver is located on the right hand side of the product, below
the burner assembly. Slide the RF reciever out, slide the battery cover
off and replace the batteries as necessary.
4.8.4 Replace the “Concept” fascia from the product and put it in a safe
location.
NB The handset uses one LR61 (9v) and should be replaced by
removing the cover on the rear of the handset.
ENSURE THE BATTERIES ARE CONNECTED TO THE CORRECT POLARITY
POSITVE (+), NEGATIVE (-)
PARTS SHORTLIST
Replacement of parts must be carried out by a competent person such as a
CORGI registered gas installer. The part numbers of the replaceable parts are as
follows, these are available from your local stockist, whose details may be found
on the BFM Europe website, address as per rear page.
On / Off Switch & Supply Wires B-93320
Base Fibre Board B-110210
Gas Control Valve B-92200
Receiver Unit B-92740
Injector B-66390
Ignition Lead B-50380
Thermocouple Interupter B-93310
Ceramic Log Set (Complete) B-108990
Log A B-109000
Log B B-109010
Log C B-109020
30
To Next Page
Loading...
