Need help?Do you have a question about the Kinetico Essential 8 and is the answer not in the manual?
General| Stages | 4 |
|---|---|
| Membrane Type | Thin Film Composite |
| Type | Reverse Osmosis |
| Pre-filter | Sediment and Carbon |
| Post-filter | Carbon |
| Filtration Process | Reverse Osmosis |
Determining the optimal placement for the water softener unit.
Checking the incoming water pressure before installation.
Plumbing the unit, connecting pipes, and following regulations.
Rinsing the pipework to remove debris before connecting the softener.
Connecting the necessary tubing for drain and overflow functions.
Removing a clip to allow adjustment of the regeneration frequency.
Adjusting the unit's settings based on water hardness.
Connecting hoses and adapters to the control valve.
Re-testing water pressure and adjusting pressure reducing valve if needed.
Ensuring the drain line is securely connected and compliant.
Opening the main inlet valve and checking for leaks.
Adding water and tablet salt to the softener cabinet.
Initiating the regeneration cycle to test the system.
Performing final leak checks and explaining operation to the customer.
Lists the components included in the By-pass Kit.
Important points to consider before installing the By-pass Kit.
Steps for installing the By-pass Kit.
Lists the components included in the Gap Trap Kit.
Important points to consider before installing the Gap Trap Kit.
Detailed steps for installing the Gap Trap Kit.
Visual guide for installing the Gap Trap Kit.
To Next Page