Kinetico Essential 8 User Manual

Essential 8 and 11 Water Softener | Installation and User Manual
07
Figure 1:
Typical installation
Your installation may vary.
1. A non-return valve (included in the Kinetico by-pass set) is required on the mains
water supply to the softener.
2. Fit a pressure regulating valve, if required, on the mains water supply to the softener.
3. Plumb a drain line from the softener to a waste pipe through an appropriate air gap
compliant with water regulations.
4. Consult WRAS Information and Guidance Note, no. 9-07-01 for regulatory advice.
Inlet
Inlet Only
Outlet
For illustration purposes only.
Note: Air gap waste fitting contains a water trap.

Kinetico Essential 8 Specifications

General

Brand	Kinetico
Model	Essential 8
Category	Water Dispenser
Language	English