Kinetico Premier Compact Water Softener Installation Instructions
10
Locate:
a: Ensure the unit can be
positioned on a flat surface.
b: If sand, silt or turbidity is
present in the water supply,
a separate prefilter should
be installed before the water
softener.
1
Test water pressure:
Test incoming pressure to the
unit. A pressure regulating valve
will be required if the pressure
is above 6 bar.
4
1
2
3
4
5
6
0
bar
Installation instructions
Please note:
The softener can be installed with the
connections on the left or right side of the
cabinet by reversing the components.
Remove cardboard:
Ensure all cardboard is removed
from the inside of the softener.
b: Remove top lid and support bar
(see page 7).
c: Carefully remove the two pieces
of cardboard, then replace the
support bar and lid.
2
Insert the
blanking plate:
Insert the blanking plate into the
outlet which is not in use.
3
THIS DRAWING AND ITS CONTENTS ARE THE PROPERTY OF KINETICO
INCORPORATED. THEY HAVE BEEN LOANED TO YOU FOR A LIMITED TIME AND
PURPOSE, AND MAY NOT BE COPIED OR DUPLICATED WITHOUT THE WRITTEN
PERMISSION OF AN AUTHORIZED EMPLOYEE OF KINETICO INCORPORATED.
ADDITIONALLY, THE PROCESS, METHOD, DESIGN AND DATA CONTAINED HEREIN,
ARE CONSIDERED TO BE THE PROPERTY OF KINETICO INCORPORATED AND MAY
NOT BE DIVULGED TO ANY OTHER PERSON OR COMPANY NO
R USED TO
KINETICO'S DISADVANTAGE
REV DESCRIPTION ECO DATE BY APPRVD
Lift up into position, then
carefully drop the plate down
into the slot.
To Next Page
Loading...
