Kingfisher FPCSP46-2 - Maintenance Table; Chain Catcher

43
FPCSP46-2
In more detail . . .
Cleaning the guide bar
> Disassemble the guide bar (2) and saw chain in
reversed order from assembly.
> Remove any dirt accumulated inside the guide bar
slot using the putty knife (not provided) (Fig. 42).
> Use a damp, lint-free cloth to clean the surface.
> Wipe the surface with a dry cloth afterwards.
Maintenance table
Inspect and maintain this product regularly based on below maintenance table. Keep
the chain saw in good working condition during maintenance.
Part Task Before/after
each use
Every 10 hours
of operation
Every 25 hours
of operation
Cylinder
ns
clean X
Spark plug
check X
clean X
replace whenever necessary
Air lter
check X
clean X
replace whenever necessary
Fuel lter
clean whenever necessary
replace whenever necessary
Saw chain
check X
lubricate X
clean X
replace whenever necessary
Chain catcher
Replace a damaged or worn chain catcher (20) with a new one of the same type.
1. Loosen the screw of the chain catcher and remove it.
2. Fix a new chain catcher to the product.
42
2
Care and maintenance