Kingfisher FPCSP46-2 - Troubleshooting

52
FPCSP46-2
In more detail . . .
Troubleshooting
Suspected malfunctions are often due to causes that the operators can x themselves.
Therefore check the product using this section. In most cases, the problem can be
solved quickly.
WARNING! Only perform the steps described in these instructions! All further
inspection, maintenance and repair work must be performed by an authorised
service centre or a similarly qualied specialist if you cannot solve the problem
yourself!
Problem Possible cause Solution
Engine does
not start
Tank empty? Check before starting!
Stop switch on O? Follow the engine starting
procedure.
Incorrect starting procedure? Follow the engine starting
procedure.
Spark plug connector not rmly
attached?
Attach the spark plug connector
rmly.
Spark plug connector is dirty? Clean the spark plug connector.
Excess fuel in the combustion
chamber?
Loosen throttle trigger lock-out,
press in choke knob, start engine
several times.
If the engine does not start:
remove spark plug and dry off
electrode
Spark plug is soiled (tip is
rusted)?
Clean spark plug
Primer has been pressed at
warm start?
Clean spark plug
Distance from electrode to
spark plug too great?
Set gap between electrodes
between 0.7 mm
Incorrect fuel or incorrect
mixture?
Empty tank and ll up with the
correct mixture
Filter for fuel-oil mixture
clogged?
Have an expert replace it.
Troubleshooting