Kingfisher FPCSP46-2 - Page 53

53
FPCSP46-2
In more detail . . .
Problem Possible cause Solution
Engine does
not start.
Spark plug defective? Replace spark plug.
Engine cold? Follow cold starting procedure.
Carburetor setting not correct? Adjust the carburetor.
Engine does
not reach
the maximum
speed.
Air lter is soiled? Clean the air lter.
Spark plug is soiled (tip is
rusted)?
Clean spark plug.
Distance from electrode to spark
plug too great?
Set gap between electrodes
between 0.7 mm.
Incorrect fuel or incorrect
mixture?
Empty tank and ll up with the
correct mixture.
Carburetor setting not correct? Adjust the carburetor.
Excess
smoke from
the engine.
Incorrect fuel or incorrect
mixture?
Stop the engine and empty
tank, then ll up with the correct
mixture.
Chain does
not start.
Chain brake triggered? Loosen chain brake.
Chain starts
up before
throttle trigger
is pressed.
Chain brake is not engaged? Engage chain brake.
Idling speed too high? Press throttle trigger again
slightly after starting.
Adjust the carburetor.
Insufcient
chain
lubrication/
grease.
The saw chain oil tank empty? Fill up saw chain oil.
Oiling port clogged? Clean oiling port.
Wrong saw chain lubrication
setting?
Increase the saw chain
lubrication.
Troubleshooting