Kingfisher NMHT450 - Blade Maintenance; General Cleaning Procedures

EN
20
EN
In more detail...
NMHT450
Operation / Care and maintenance
General Cleaning
1. Clean the product with a damp cloth and pH-neutral soap. Use a brush for
areas that are hard to reach.
2. In particular clean the air vents (5) after every use with a cloth and brush.
3. Remove stubborn dust with high pressure air (max. 3 bar).
NOTE: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be
harmful to its surfaces.
4. Check for worn or damaged parts. Replace worn parts as necessary or contact
an authorised service centre for repair before using the product again. Check
for worn or damaged parts. Replace worn parts as necessary or contact an
authorised service centre for repair before using the product again.
Cutting device (blade)
WARNING! Wear safety gloves when working on the cutting device
and close to it! Use appropriate tools to remove debris, e. g. a brush or
wooden stick! Never use your bare hands!
1. Keep the cutting device (blade) (1) clean and free of debris. Remove trimmings
with a brush.
2. Apply a small amount of suitable lubricant on the cutting device (blade) to
retain a good cutting performance (Fig. 9).
Power cord
If the power cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualied persons in order to avoid a safety hazard.
No name_MNL_NMHT450_Electric Hedge Trimmer_GB_V3_210918_UK.indd 20 9/22/21 4:31 PM