NOTE :
• Make sure stop engine completely prior to checking and adjusting.
(for details please refer to the attached check list.)
8.3 Maintenance check list
Frequency
Check Notes Remarks
of check
Initial operation
(first 60 hours)
Daily checks
(check every-
time pior to
u s e )
1) Check completely all abnormalities found
during previous operation.
2) Go around the tractor and check the
following points
1. Air pressure, wear and general
condition of tires
2. Oil or water leakage
3. Amount of engine oil and degree of
c o n t a m i n a t i o n
4. Amount of transmission oil and degree
of contamination
5. Amount of fuel and coolant
6. Condition of dust cup in air cleaner
7. Tractor body for damage, loosened
bolts and nuts
8. Condition of lamps
9. Dirt or damage of the number plate
3) While in the driver’s seat check the
following
10. Operation of brake pedals and clutch
p e d a l s
11. Operation of parking brake
12. Operation of steering wheel
13. Dirt on lamps and operation of lamps
14. Operation of all meters and gauges
15. Color of exhaust gas
16. Operation of winkers
See page 36
The oil level must be between the
two marks on the dipstick.
The oil level must be to the top line
on the dipstick.
Stop the engine while adding oil.
During this period, pay attention to the following
1) After the first 35 hours of use, change the engine oil.
2) After the first 50 hours of use, change the transmission oil, front axle
case oil and hydraulic oil filter.
3) Sudden starting or sudden braking should be avoided.
4) When the outside temperature is low, allow the engine to warm-up prior
to operation.
5) Unusually fast driving must be avoided.
6) Reduce speed on slopes or during bad road conditions.
To Next Page
Loading...
