(1) Adjusting Bolt
(A) Adjusting Belt Tension (B) Pull
ADJUSTING FAN BELT TENSION (V)
In order to extend the fan belt’s lifeti-
me, the tension of the belt should be
correctly adjusted if it slips. The belt
tension should be inspected regularly
according to the following procedure:
1. Stop the engine and apply the
parking brake.
2. Open the hood.
3. In order to measure the belt ten-
sion, apply thumb pressure stron-
gly to the “A” location of belt.
td2O725A
WARNING
Stop the engine when che-
cking the items above.
Inspect the fuel pipe regular-
ly. The fuel pipes are subject
to wear and aging. Failure to
perform periodic inspections
may lead to a fuel leak. Fuel
leaking on a hot engine could
cause a re.
•
•
IMPORTANT
When disconnecting the fuel
pipe for replacement, plug
both ends with cloth or paper
to prevent dust or foreign ma-
terial from entering it. Othe-
rwise, the fuel injection pump
can be damaged. Pay extra
caution to the fuel pump to
prevent dust from entering it.
•
3. If the fuel pipes and hose clamps
are found damaged or deteriora-
ted earlier than two years, then
change them immediately.
4. After the fuel pipe and hose clam-
ps have been changed, bleed the
fuel system.
To Next Page
Loading...
