OPERATION 5-15
ATTACHING AN IMPLEMENT
C71O516A
CAUTION
A label with attachment instruc-
tions can be found on imple-
ments manufactured by DAE-
DONG.
When attaching an implement that
does not require high traction
(such as a mower), connect the
top link to position A.
When attaching an implement that
requires high traction (such as a
plow), connect the top link to po-
sition B or C. Position C is used
for implements where greater
sensitivity and response are re-
quired (plow, box blade).
Always use position A when
transporting any implement. Fail-
ure to do so may result in unex-
pected movement of the
implement.
LIFTING DEVICES FOR AN ATTACH-
MENT
The hydraulic lift will raise and lower
implements attached to the 3-point hitch.
It can be operated anytime that the en-
gine is running; whether or not the clutch
is engaged.
POSITION CONTROL
Operating the position control lever ac-
tuates the hydraulic lift arm. This con-
trols the elevation of the 3-point hitch
mounted implement.
Place the position control lever in a suit-
able position and set the implement pull
with the draft control.
C71O517B
(1) Position Control Lever
WARNING
The implement can be lowered
even with the engine off. Take spe-
cial care not to do this inadver-
tently. Never leave an implement
in the raised position.
To Next Page
Loading...
