6-10 DK65S
1. Remove the engine oil filter using a
suitable filter wrench.
2. Apply a light coat of clean oil on the O-
ring of the new filter. Install and hand
tighten.
3. Add engine oil as needed to bring the
oil level to the correct level.
4. Start the engine and run for 5 minutes
and check for leaks.
5. Verify that the oil pressure warning light
has gone off.
6. Stop the engine, wait 5 minutes and
recheck the oil level.
CHANGING FILTERS
CHANGING ENGINE OIL FILTER
C71O610B
(1) Engine Oil Filter
FRONT AXLE OIL CHANGE
C71O609A
Front differential oil
capacity
4.5
(1.2 U.S.gal.)
(1) Drain Plugs
(2) Oil Level Sight Gauge
(3) Oil Fill Plug
Front axle housing
oil capacity
3.5
-per side
(0.9 U.S.gal.)
1. To drain the used oil, remove the right
and left drain plugs and filling plug at
the front axle case and drain the oil
completely into the oil pan.
2. After draining, reinstall the drain plugs.
3. Remove the oil level check plug.
4. Fill with the new oil up to the check plug
port.(See “LUBRCANTS” in Mainte-
nance Section)
5. After filling, reinstall the filling plug and
check plug.
To Next Page
Loading...
