MAINTENANCE 6-17
2
DRAINING WATER FROM THE CLUTCH HOUSING
C71O624A
Water can accumulate in the clutch hous-
ing if submerged in water or during pres-
sure washing. Remove the drain plug from
the clutch housing every 50 hours to drain
any water from the housing.
(1) Drain Plug
CHECKING AND ADJUSTING FRONT AXLE
C71O623B
If loose or improperly adjusted, front axle
vibration can occur. To adjust the front
axle, loosen the nut and fully tighten the
bolt. Loosen the bolt 1/16 of a turn and
retighten the nut.
(1) Nut
(2) Bolt
TOE-IN ADJUSTMENT
C71O622A
(1) Tie Rod
(2) Lock Nut
1. Loosen the lock nut and turn the turn-
buckle to adjust the rod length until the
proper toe-in measurement is obtained.
2. Retighten the lock nut.
To Next Page
Loading...
