What causes no or low AC output on Kipor IG2000P?
For no or low AC output on your Kipor Portable Generator: * Replace the AC receptacle. * Check and repair the stator wire harness or replace the stator; if the rotor inner magnetism decreases, replace the rotor. * Replace the inverter unit.
General| Brand | Kipor |
|---|---|
| Model | IG2000P |
| Category | Portable Generator |
| Language | English |
Provides detailed specifications for engine and generator models, including dimensions and weight.
Lists electrical and operational characteristics such as output, voltage, frequency, and power factor.
Graphical representation of generator performance under various conditions.
Illustrations showing the physical dimensions and layout of the generators.
Schematics illustrating the electrical connections and layout of the generator.
Explains the critical role of correct servicing for safety and engine reliability.
Essential safety guidelines to follow during maintenance and repair operations.
General rules and best practices for performing service and repairs.
Identifies the location of the engine serial number for ordering and inquiries.
Specifies standard and service limit measurements for engine components.
Lists recommended torque specifications for various fasteners.
Comprehensive guide for diagnosing and resolving common engine and generator issues.
Outlines regular service periods for various engine components and tasks.
Covers checking and replacing engine oil, including recommended types and capacity.
Procedure for checking the functionality of the low oil alarm system.
Instructions for inspecting and cleaning the air cleaner element.
Guidance on inspecting, cleaning, and replacing the spark plug.
Steps for inspecting and adjusting valve clearance on a cold engine.
Procedures for cleaning and inspecting the fuel tank and fuel filter.
Instructions for checking and replacing fuel tubes and the fuel pump.
Procedure for cleaning and inspecting the spark catcher.
Procedures for removing and reinstalling the muffler, including cleaning.
Instructions for disassembling and installing the air filter unit.
Detailed steps for disassembling and installing the carburetor and its components.
Methods for inspecting carburetor float height and stepping motor resistance.
Steps for removing and reinstalling the control panel assembly.
Tests for AC/DC receptacles, smart switch, ignitor, engine switch, and communication ports.
Instructions for disassembling and installing the lamp chimney unit.
Steps for disassembling and installing the left and right housing cases.
Procedure for removing, cleaning, and installing the fuel tank.
Methods for measuring resistance and capacitance of specific electrical components.
Steps for disassembling and reassembling the recoil starter and ignition coil.
Detailed instructions for correctly installing the recoil starter mechanism.
Procedures for measuring ignition coil resistance and checking rectifier operation.
Measuring resistance of ignition, charging, sub, and main windings.
Inspection of generator windings and trigger resistance.
Procedure for adjusting the clearance between the trigger and rotor projection.
Steps for disassembling, reassembling, and inspecting cylinder cover and rocker arm.
Measuring outer and inner diameters of rocker arm and its bearing.
Steps for disassembling the crankcase cover and cam timing drive chain.
Overview of components related to the crankcase cover.
Procedure for installing and aligning the roller chain and timing marks.
Instructions for assembling chain support plate and pressure plate.
Steps for cleaning sealing surfaces and reassembling the crankcase cover.
Inspection of oil alarm, cam height, and related components.
Steps for disassembling and reassembling crankshaft, piston, and related valve components.
Instructions for installing piston, piston pin, and piston rings with correct orientation.
Detailed measurements for valve spring, seat width, rod diameter, clearance, and piston dimensions.
To Next Page
