EasyManuals Logo

Kipor Sinemaster IG3000 Operation Manual

Kipor Sinemaster IG3000
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
13
be exceeded, the circuit protection device will activate and cut all
current to the receptacle. This will be indicated by the push button
popping out. Reduce the load to the receptacle and reset the circuit
protector by pushing in the button.
Before connecting an appliance to the generator, check that it is in
good order, and that its electrical rating does not exceed that of the
generator. .
When an electric motor is started, both the overload indicator light
and the output indicator light may go on simultaneously. This is
normal if the overload indicator light goes off after about four seconds.
If the overload indicator light stays on, consult a service center.
5.4 Overload Reset Switch
Should the generator’s maximum load of 25 watts be exceeded, AC power will be cut off but the
engine will stay running. Correct the overload condition and then press the overload reset switch on
the front panel. AC power will be restored immediately.
5.5 SMART Throttle
SMART throttle switch
DC receptacle
Ignition Module
Engine switch
Choke knob
Fuel valve lever
Ground terminal
AC receptacle
Overload protection device
Overload Reset Switch

Other manuals for Kipor Sinemaster IG3000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kipor Sinemaster IG3000 and is the answer not in the manual?

Kipor Sinemaster IG3000 Specifications

General IconGeneral
Rated Power2.8 kW
Maximum Power3.0 kW
Max. AC Output3.0 kVA
Rated Voltage230 V
Rated Frequency50 Hz
Power Factor1.0
Engine Type4-stroke, OHV, single cylinder
Displacement196 cc
Fuel TypeUnleaded Gasoline
Fuel Tank Capacity13 L
Starting SystemRecoil start
Noise Level65 dB at 7 m

Related product manuals