11
PRODUCT USAGE
NOTE: See the Use and Care Guide of each specific attachment for recommended
speed settings and operating times.
Insert attachment shaft housing into
Attachment Hub, making certain that
attachment power shaft fits into square
Attachment Hub socket. It may be
necessary to rotate attachment back
and forth. When attachment is in proper
position, the pin on the attachment will fit
into the notch on the hub rim.
3
Replace Attachment Hub cover. Tighten
Attachment Knob by turning it clockwise.
8
To remove: Turn speed control to
“0” (OFF). Unplug Stand Mixer.
6
Tighten Attachment Knob by turning
clockwise until attachment is completely
secured to Stand Mixer. Plug into proper
electrical outlet.
4
Loosen Attachment Knob by turning it
counterclockwise. Rotate attachment
slightly back and forth while pulling out.
7
Plug into proper electrical outlet.
5
W11520569A.indb 11W11520569A.indb 11 6/17/2022 3:26:12 PM6/17/2022 3:26:12 PM
To Next Page
Loading...
