KitchenAid 720-0733D - Gas Conversion Gas Conversion; Tools and Parts for Gas Conversion; Conversion from LP Gas to Natural Gas

GAS CONVERSIONS
Tools and Parts for Gas Conversion
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
1 T ff th i l l
Conversion from LP Gas to Natural Gas
Installation of the regulator
Read
and
follow
the
instructions
provided
with
any
tools
listed
here.
1
.
T
urn o
ff
th
e ma
i
n gas supp
l
y va
l
ve.
2. Disconnect 20 lb LP gas fuel tank (if present).
3. Turn off all burner control valves.
4. Remove the 20 lb LP gas fuel tank (if present) from the
grill cart.
5. Use an adjustable wrench to remove the LP regulator
from the manifold.
Tools needed
 Phillip screwdriver
 Pipe Wrench
 Adjustable wrench

6 mm socket and
Thin flat-blade
screwdriver
 Needle Nose Pliers

Pipe thread sealant
Parts supplied
 Natural gas orifices
Parts needed
 Natural gas conversion kit Part Number 710-0003. See
 “
Assistance
”
section to order. The conversion kit includes:

6
mm
socket
and
wrench or 6 mm nut
driver
Pipe
thread
sealant
certified for LP gas
Assistance
section
to
order.
The
conversion
kit
includes:
 Natural gas regulator 4" W.C. (marked “Natural Gas
 Regulator”)
 10 ft (3.0 m) Natural gas hose with quick connector
 5.9" (150 mm) Natural gas regulator hose
 6 mm nut driver
 6 mm wrench
 Hex key
6. Use an adjustable wrench to install the Natural gas
regulator hose to the manifold and secure. Attach the
Natural gas regulator to the side panel inside the grill
cart with the two screws that are preassembled on the
re
g
ulator.
IMPORTANT: Gas conversions must be done by a qualified
installer. Before proceeding with conversion, shut off the gas
supply to the appliance.
g
18