KitchenAid 720-0733D - Outdoor Grill Care; Replacing the Igniter Battery; General Cleaning

OUTDOOR GRILL CARE
Replacing the igniter Battery
GRILL GRATES
If igniters stop sparking, the battery should be replaced.
1 The igniter button cap is located on the outside of the grill
’
s
IMPORTANT: To avoid damage to grill grates, do not use a steel
or fiber scra
p
er. Immediatel
y
after
y
ou are finished cookin
g,
1
.
The
igniter
button
cap
is
located
on
the
outside
of
the
grill s
right side panel.
2. Unscrew igniter button cap counterclockwise to remove.
pyy g,
loosen food soil with a brass bristle brush. Turn all burners to
HIGH for 10-15 minutes with the hood closed to burn off food soil.
Turn off all burners, raise the hood and let grates cool. Use the
brass bristle brush to remove ash from the grill grates.
When completely cool, grill racks can be removed for thorough
cleaning. Clean them with a mild detergent and warm water.
For baked-on soil, prepare a solution of 1 cup (250mL) ammonia
to 1 gal. (3.75 L) water. Soak grates for 20 minutes, then rinse
with water and dry completely
2. Remove battery from the battery compartment.
3 Replace with a new alkaline
“
AA
”
size battery Install
Cleaning Method:
 Liquid detergent or an all-purpose cleaner.
 Rinse with clean water and dry with soft, lint-free cloth.
 For tough spots or baked-on grease, use a commercial
degreaser.
IMPORTANT: Make sure
g
as su
pp
l
y
is off and all control knobs
with
water
and
dry
completely
.
WARMING SHELF
A.”AA” size battery
B. Igniter cap
3
.
Replace
with
a
new
alkaline
AA
size
battery
.
Install
battery with negative end in first.
4. Screw igniter button cap clockwise into place.
IMPORTANT: Before cleaning, make sure all controls are off and
the grill is cool. Always follow label instructions on cleaning
products.
gppy
are in the OFF position.
The quality of this material resists most stains and pitting,
providing that the surface is kept clean, polished and covered.
 Apply stainless steel polish to all non-cooking areas before
first use. Reapply after each cleaning to avoid permanent
dtf
General Cleaning
EXTERIOR
products.
For routine cleaning, wash with soap and water using a soft cloth
or sponge. Rinse with clean water and dry at once with a soft,
lint-free cloth to avoid spots and streaks.
Do not use steel wool to clean the grill, as it will scratch the
surface.
To avoid weather damage to finish, use grill cover.
d
amage
t
o sur
f
ace.
 Cleaning should always be followed by rinsing with
clean warm water. Wipe the surface completely dry with a
soft cloth.
 For tough spots or baked-on grease, use a commercial
degreaser stainless steel.
STAINLESS STEEL
INTERIOR
Cleanin
g
Method:
IMPORTANT: To avoid damage to stainless steel surfaces, do
not use soap-filled scouring pads, abrasive cleaners, cooktop
polishing creme, steel wool, gritty wash cloths or paper towels.
Cleaner should not contain chlorine. Damage may occur.
Food spills should be cleaned as soon as entire grill is cool. Spills
may cause permanent discoloration.
Discoloration of stainless steel on these parts is to be expected,
due to intense heat from the burners. Always rub in the direction
of the grain. Cleaning should always be followed by rinsing with
clean, warm water.
Cleaning Method:

Liquid detergent or all
-
purpose cleaner.
 Rub in direction of grain to avoid scratching or damaging the
surface.
 Stainless steel cleaner.
 Liquid detergent or all-purpose cleaner.
 Rinse with clean water and dry with soft, lint-free cloth.
 Vinegar to remove hard water spots.
 Glass cleaner to remove fingerprints.
g
Liquid
detergent
or
all
purpose
cleaner.
 Rinse with clean water and dry completely with a soft, lint-
free cloth.
 A heavy-duty scrub sponge can be used with mild cleaning
products.
 For small, difficult-to-clean areas, use a commercial
degreaser designed for stainless steel.
29