7
ENGLISH
NOTE: To avoid damage to the
fruit/vegetable strainer attachment and/or
mixer, Labruscan or slip-skin type grapes
such as Concord, Catawba and Ontario
grapes should not be processed in the
Fruit/Vegetable Strainer. Only Ninifera
family grapes such as Tokay and Thompson
Seedless may be processed.
To Clean Fruit/Vegetable Strainer
Attachment
First completely disassemble fruit/vegetable
strainer attachment.
The following parts are dishwasher safe:
• Grinder body
• Grinder worm
• Strainer cone
• Strainer tray
• Splash shield
• Ring
• Combination food pusher/wrench
The following parts should be hand
washed in warm, sudsy water and
dried thoroughly:
• Spring and shaft assembly
Some foods may stain certain parts. These
stains may be removed by using one of the
following methods: (1) place dishwasher
safe parts in dishwasher and use cycle for
normally soiled dishes, or (2) rub a small
amount of oil or shortening over the stains,
wash in warm, sudsy water and rinse. A
small bottle brush can be used to help
remove pulp from the strainer cone.
To Loosen Ring – If ring is too tight to
remove by hand, slip the combination
food pusher/wrench over the grooves and
turn counterclockwise.
NOTE: To avoid damage to the fruit/
vegetable strainer attachment, do not
use combination food pusher/wrench to
tighten ring to grinder body.
Fruit/Vegetable Strainer Parts (Model FVSP)
are available to convert a Model FGA Food
Grinder to a Fruit/Vegetable Strainer.
Fruit/Vegetable Strainer Attachment
To Next Page
Loading...
