EasyManua.ls Logo

KitchenAid KWB110 - Baking and Serving Tips; Care and Cleaning

KitchenAid KWB110
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
TIPS FOR GREAT RESULTS
Baking and serving tips
Whether one or two wafes are being
prepared, always rotate the baking unit
after lling a wafe plate. This coats both
the upper and lower wafe plates with
batter and ensures the nest consistency.
Don’t over-ll the wafe plates. Pour
the batter onto the center of the plate,
then evenly spread it out to the edges
using a soft spatula or the bottom of a
non-metallic ladle. The batter should
almost cover the peaks of the wafe grid.
Use a pitcher instead of a ladle: it’s much
easier to pour batter than to ladle it.
Close the baker lid immediately after
removing a wafe. This helps maintain the
proper baking temperature for additional
wafes.
Wafes will lose their crispiness if stacked
or placed on a solid surface. For the best
results, keep wafes on a wire rack before
serving.
When preparing multiple wafes for
serving, keep the nished wafes warm
by placing them in a 200° F (93° C) oven
for up to 15 minutes. Lay the wafes in
a single layer directly on the oven rack.
Wafes can also be warmed by placing
them into a pre-heated Wafe Baker for
1 minute.
Extra wafes can be frozen with very
good results. Cool the leftovers in a
single layer on a wire rack, separate the
wafes with wax paper, and place them
in a plastic freezer bag or other airtight
container before putting them into the
freezer. When you’re ready to enjoy
them, lay frozen wafes in a single layer
directly on the oven rack and heat for 10
minutes at 300° F (150° C). Frozen wafes
can also be heated by placing them into
a pre-heated Wafe Baker for 2
1
/
2
to 3 minutes.
CARE AND CLEANING
1
Open the baker lids and wipe the waffle
plates clean with paper towels or a
damp cloth.
2
Wipe the exterior of the Waffle Baker
with a warm, sudsy cloth; then wipe
clean with a damp cloth and dry with a
soft cloth.
NOTE: Do not immerse the Wafe Baker in water. Do not use abrasive cleaners or scouring
pads.
IMPORTANT: Make sure the Wafe Baker is switched off, unplugged, and completely cool
before cleaning.
W10591298A_ENv7.indd 12 4/7/14 2:50 PM

Table of Contents