5
COOKTOP USE
Cooktop Controls
IMPORTANT: Your cooktop is factory-set for use with Natural
gas. If you wish to use LP gas, an LP Gas Conversion Kit is
included with your new cooktop. See the instructions included
with the LP Gas Conversion Kit for details on making this
conversion.
Electric igniters automatically light the surface burners when
control knobs are turned to LITE.
The TripleTier
®
Flame Burner (18,000 Btu/h [British Thermal
Units]) provides the highest heat setting, and is ideal for cooking
large quantities of food or liquid, using large pots and pans.
The medium burners (15,000 Btu/h) provide the high heat setting,
and are ideal for cooking large quantities of food or liquid, using
larger pots and pans.
The small burners (6,000 Btu/h) allow more accurate simmer
control at the lowest setting, and are ideal for cooking smaller
quantities of food, using smaller pots and pans.
Before setting a control knob, place filled cookware on the grate.
Do not operate a burner while using empty cookware or without
any cookware on the grate.
NOTE: Visually check that the burner has lit. If the burner does
not ignite, listen for the clicking sound. If you do not hear the
igniter click, turn off the burner. Check for a tripped circuit
breaker or blown fuse.
Check that the control knob is pressed completely down on the
valve shaft. If the spark igniter still does not operate, call a trained
repair specialist.
Proper grounding and polarity are necessary for correct operation
of the electric ignition system. If the wall receptacle does not
provide correct polarity, the igniters will become grounded and
occasionally click, even after the burner has ignited. Contact a
trained repair specialist to check the wall receptacle to see
whether it is wired with the correct polarity.
Standard Valve Control
To Se t:
1. Push in and turn knob counterclockwise to LITE.
All surface burners will click. Only the burner with the control
knob turned to LITE will produce a flame.
2. Turn knob anywhere to between HI and LO. Use the following
chart as a guide when setting heat levels.
Dual Valve TripleTier
®
Burner Control
To Se t:
1. Push in and turn knob counterclockwise to LITE.
All surface burners will click. Only the simmer burner with the
control knob turned to LITE will produce a flame.
2. Turn knob to anywhere between SIMMER BURNER HI and
LO.
WARNING
Fire Hazard
Do not let the burner flame extend beyond the edge of
the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in death
or fire.
REMEMBER:
When cooktop is in use, the entire cooktop
area may become hot.
SETTING RECOMMENDED USE
LITE
■ Lite the burner.
HI
■ Start food cooking.
■ Bring liquid to a boil.
MED to HI
■ Hold a rapid boil.
■ Quickly brown or sear food.
MED
■ Fry or sauté foods.
■ Hold a slow boil.
MED to LO
■ Cook soups, sauces and gravies.
■ Stew or steam foods.
LO
■ Keep food warm.
■ Simmer.
Med
Lo
Hi
Lite
OFF
S
I
M
M
E
R
B
U
R
N
E
R
P
O
W
E
R
B
U
R
N
E
R
Hi
M
ed
Lo
Hi
Med
Lo
Lite
OFF
To Next Page
Loading...
Need help?
General
