Kitvision Escape HD5W - Using Photo Mode

G Sensor Set the camera to stop the video recording
automatically when it is not moving. When the camera
moves again, it will start the recording automatically
[Off] / [Low] / [Mid] / [High]
Resolution Change the photo resolution depending on desired
quality.[12MP] / [10MP] / [8MP] / [6MP] / [3MP] /
[2MP] /[VGA]
Exposure Change the exposure of the Photo mode
[-2.3] / [-1/3] / [0.0] / [+1/3] / [+2/3] / [+1.0] / [+4/3] /
[+5/3] / [+2.0]
Quality ChangethequalityofthePhotoMode
[Super Fine] / [Fine] / [Normal]
ISO Change the ISO levels of the Photo Mode
[Auto] / [100] / [200] / [400]
Burst Change the amount of photos taken in Burst mode.
[Off] / [3 Burst] / [5 Burst] / [10 Burst]
White Balance Change the white balance of the Photo mode
to suit the environment
[Auto] / [Daylight] / [Cloudy] / [Tungsten] /
[Fluorescent]
Anti-Shake Activate anti-shake to reduce blurring when
photographing moving objects and to digitally
stabilise the camera sensor [Off ] / [On]
Time Lapse ChangethefrequencyofphotostakeninTimeLapse
mode. Choosing ‘short’ will reduce the time between
photos and ‘long’ will increase the time between
each photo
[Short] / [Long]
Sharpness Change the sharpness of the Photo mode
[Strong] / [Normal] / [Soft]
Power Save Change the time in which the camera
will enter sleep mode
[Off] / [10 sec] / [30 sec] / [1 min]
1918