Kitvision explore 1080p - Instructions for Use

6 7
Instructions for use
Turning power on and o
1. Long Press the Power/Mode button (3) to turn on the camera.
2. Long press the Power/Mode button (3) to turn o the camera.
Charging the battery
The camera has a built-in rechargeable lithium battery. Please fully charge the
battery before use.
1. Turnothecamera.
2. Connect the micro USB connector of the USB cable to the camera and the
other end to a PC/mains charger USB port.
Note: The camera will turn back on once connected to a power source,
forthemostecientchargingturnthecameraobyholdingthePower/
mode button (3).
3. The Charging Indicator (8) will be solid blue whilst charging.
4. OncefullychargedtheChargingIndicator(8)willturno.
Note: The camera body may be warm after extended use. This is normal.
Inserting the memory card
The Explore 1080 Action Camera doesn’t have any internal memory. To be
able to record video or capture photos using the camera, you must have your
micro SD card inserted (32 GB max, not included).
1. Ensurethecameraisturnedo.
2. Insert your memory card into the micro SD card slot (5).
3. ThecamerausestheFAT32leformat.IfthemicroSDcardisincompatible,
it will need formatting.
4. To format the card correctly, go to the ‘Changing the Camera Settings’
section on page 16 and follow the ‘General Settings’ instructions.