Kitvision explore 1080p - Changing the Camera Settings

16 17
Changing the camera settings
General settings
1. To enter the general settings menu, turn on the camera and press the
Power/Mode Button (3) until the Settings mode is selected.
2. PresstheShutter/OkButton(1)toconrmtheselection.
3. Use the Up Button (10) and Down Button (12) to navigate through the
Setup Menu.
4. Use the Shutter/Ok Button (1) to enter a sub-menu.
5. Use the Power/Mode Button (3) to return to the setup menu.
Inthegeneralsettingsmenu,youwillndthefollowingoptions:
Menu Function
Video Resolution
Change the video resolution for the video recording. Select a
smallermoviesizeforreducedlesizeorahighermoviesize
for better quality
[1080P (30fps)] / [HD 720P (60fps)]
Looping Video
With this setting ON the camera will record the video in 5 minute
length video clips to the SD card
[O]/[ON]
Time Stamp
This function can be used to add a date and time stamp to your
videos as you take them
[OFF] / [Date & Time]
Exposure
Use the Exposure slider to change the exposure of your video
This can be used to compensate light when using the camera in
very bright or dark situations.
[+/– 2.0]